Continuing the discussion from Booting from USB stick:
Hi @Mohar ,
you’re right, in boot2qt there is no overlays for the device tree.
Just a short note from my side. Converting the files from dtb to dts is not correct. You would need to provide a dtb (device tree binary) to successfully get it running. The dts (device tree source) is where you would make changes to the device tree.
I recommend looking into this article:
Furthermore, to be sure that there is no issue with the display itself, did you try to flash any other image over the Toradex Easy Installer onto the module? Like a classic Linux distribution to see if the display shows anything?
Best Regards
Kevin