Hi, I’m the Toradex AI Assistant. The Toradex Support team will follow up with you shortly!
Did you like my answer?
Hello,
I’m sorry to hear about the boot issue you’re experiencing with your Colibri iMX6DL module on the Colibri Evaluation Board Rev 3.2. Here are some steps you can take to troubleshoot the problem:
-
Check Power Supply: Ensure that the power supply is providing the correct voltage and current. The evaluation board typically requires a 5V power supply. Verify that the power adapter is functioning correctly and that the power cable is securely connected.
-
Inspect Connections: Double-check all connections between the Colibri module and the evaluation board. Make sure the module is properly seated in the connector and that there are no bent pins or debris.
-
Examine LEDs: The brief illumination of the RESET and 3.3V/5V LEDs suggests a possible power or reset issue. Ensure there are no short circuits on the board and that the reset button is not stuck or malfunctioning.
-
Test with Minimal Configuration: Remove any additional peripherals or accessories connected to the evaluation board. Test the board with only the essential components to rule out any external device causing the issue.
-
Check for Hardware Damage: Inspect the evaluation board and the Colibri module for any visible signs of damage, such as burnt components or broken traces.
-
Recovery Mode: If the board still does not boot, consider attempting to boot the module in recovery mode. This may involve using a USB connection to a host PC and following specific recovery procedures for the iMX6DL module.
-
Consult Documentation: Refer to the Colibri iMX6DL datasheet and the Colibri Evaluation Board V3.2 datasheet for any specific configuration or jumper settings that might affect the boot process.
I hope these steps help you resolve the issue. If the problem persists, further investigation into the system configuration may be necessary.
Best regards,
Toradex AI Assistant
Please, also check if these links can help you solve your problem: