Sdk manager does not support jetson tk1

Technical Support
, , ,
1

I have ixora carrier board with apalis TK1 module.
I have installed l4t (21.7.0) to it with ubuntu 16.04.6 using easy installer :

I am trying to install jetpack for it.
i am following steps for SDK manager as mentioned below:
url: JetPack Software Stack for NVIDIA Jetson | NVIDIA Developer
SDK manager does not support jetson TK1.
this vedio explain how to install jetpack using jetpack installer
https://www.youtube.com/watch?v=J-ma4aZyqfY
It has the same steps as this url : https://docs.nvidia.com/jetpack-l4t/2_1/content/developertools/mobile/jetpack/jetpack_l4t/2.0/jetpack_l4t_install.htm , but again the installer is not exist.
so please if you can help me to find a solution so I can see jetson TK1 in SDK manager , or get .run file for jetpack installer.
thanks in advanced

2

Hi @rama and Welcome to the Toradex Community!

To install Jetpack on Apalis TK1, one can just install the corresponding image containing already Jetpack using Toradex Easy Installer as explained here.

Best regards,
Jaski

3

[upload|biib5ToruQoAHj+cTGhLmv/Aou8=]

i was facing a problem when clicking on NVIDIA’s JetPack 3.1 as shown in the figure below, i could not get .run file for jetpack installer.
anyway, now it is working fine with me.
but i have a new issue:
I CAN NOT ENTER RECOVERY MODE USING HARDWARE METHOD.
NOR ENTERRCM COMMAND METHOD
since i can not see any output on the serial output monitor when turning on the board
also can not find it as usb when typing lsusb in vmware.[upload|+UqJeLRQSMez6aUmyqDRfffQhnc=]

4

This issue is discussed here.