Reload sn65dsi83 after crc error

[ToradexAI]

Hi, I’m the Toradex AI Assistant. The Toradex Support team will follow up with you shortly!

Did you like my answer?

---

Hello,

I’m sorry to hear about the issues you’re experiencing with the sn65dsi83 MIPI to LVDS converter after the ESD test. Let’s explore some software-based solutions to reset the device without needing a full system reboot:

1. Use I2C Tools for Reset: If the sn65dsi83 has a reset register, you can attempt to reset it using the i2cset command. For example:

   i2cset -f -y 3 0x2c <register> <value>
   

   Replace <register> and <value> with the appropriate values for your device. This can sometimes clear error states.

2. Check for Updated Drivers or Firmware: Ensure that you are using the latest drivers and firmware for the sn65dsi83. Updates can sometimes resolve issues related to error handling.

3. Review System Logs: Examine the system logs for any additional error messages that might provide more insight into the issue. This can help identify if there are other underlying problems.

These steps focus on software solutions that might help reset the device. If the issue persists, further investigation into the system’s configuration or environment might be necessary.

Best regards,
Toradex AI Assistant

Please, also check if these links can help you solve your problem:

SW reset via SRC_A7RCR0

Hi, we want to SW reset the A7 cores, so the M4 does not get interrupted by the resetting A7’s. According to the Reference Manual (IMX7DRM) M4 reset is triggered by COLD and POR. So the last hope for our usecase is for the SW reset not to trigger the M4 reset. We tried to archieve this by setting the A7_CORE_RESET0 and A7_CORE_RESET1 bits of the SRC_A7RCR0 Register to 1. Edit: The following described Problem was bypassed (see Comment) This is where we are stuck. According to RM p. 1060 t…

Verdin iMX8MM DSI to LVDS display adapter flickering

Hello, I’ve been trying to implement display in our design. I connected DSI to LVDS adapter (rev 1.1) to development board (v1.1A) and connected Verdin iMX8MM SoM (V1.1B). I’ve flashed newest image using Easy Installer, this is the uname output: Linux verdin-imx8mm-06899291 5.4.154-5.5.0+git.c65f1622951c .... Then configured overlays.txt to load all the neccessary overlays as described in Device tree overlays wiki: touch-atmel-mxt_overlay.dtbo verdin-imx8mm_sn65dsi84-lt170410_overlay.dtbo …

Backlight installed but not working.