Hi, I’m the Toradex AI Assistant. The Toradex Support team will follow up with you shortly!
Did you like my answer?
Based on the context provided, it seems you are experiencing an issue with entering recovery mode after updating the device tree, which has resulted in a boot error. Here are some steps you can try to resolve the issue and enter recovery mode:
-
Ensure Proper Recovery Mode Setup: Make sure you are following the correct procedure to put your module into recovery mode. This typically involves specific hardware button presses or jumper settings on your carrier board. Refer to the “Loading Toradex Easy Installer Guide” for detailed instructions specific to your module and carrier board.
-
Check USB Connection: If you are using a USB connection to enter recovery mode, ensure that the USB cable is properly connected and try using a different cable or a non-USB3 port, as mentioned in the context.
-
Configure Carrier Board: If you are using the Ixora Carrier Board, ensure that X9 is configured in OTG mode by removing JP2, as this can affect the recovery process.
-
Use Serial Console: Access the serial console on UART1/UART_A to get more information about the error messages and to manually interact with the bootloader. This can help diagnose the issue further.
-
Review Boot Arguments: Check if any custom boot arguments (teziargs) are causing issues. You can modify these arguments to include
debugfor more detailed kernel output, which might help in diagnosing the problem.
If these steps do not resolve the issue, you may need to consult the detailed recovery mode instructions specific to your module or seek further assistance from Toradex support.
Please, also check if these links can help you solve your problem: