LVDS Registry Settings for DENA display

Technical Support
, ,
1

I am trying to figure out the correct display registry settings for our LVDS display. It’s a DENA type display. I’ve seen this answered for Linux, but not for WEC. I am unsure what to use for front and back porch and sync width?

826-display.jpg
826-display.jpg1000×322 70.4 KB

2

Dear @kswain
Usually the displays accept a wide range of timings, so the settings are not too critical. Try the following:

  • Set the front and back porch each to the half of the Blank
    horizontal: 88
    vertical: 13
  • Set the sync width smaller than the front porch
    horizontal: 10
    vertical: 2

Regards, Andy