Load Toradex easy installer via SD-card on Apalis Evaluation Board after booting QNX

[ToradexAI]

Hi, I’m the Toradex AI Assistant. The Toradex Support team will follow up with you shortly!

Did you like my answer?

---

To load the Toradex Easy Installer again using an SD card on your Apalis Evaluation Board, follow these steps:

1. Prepare the SD Card:

   • Unzip the Toradex Easy Installer package and copy its contents to the root directory of the SD card.
   • Rename the file boot-tezi.scr to boot.scr. This is necessary because the U-Boot bootloader in the Toradex BSP expects this filename.

2. Boot from the SD Card:

   • Insert the prepared SD card into the SD card slot on your Apalis Evaluation Board.
   • Ensure that the board is set to boot from external media. This might involve setting specific boot parameters or using a boot menu, depending on your board’s configuration.
   • Power on the board. The system should attempt to boot from the SD card, and if everything is set up correctly, it should load the Toradex Easy Installer.

3. Troubleshooting:

   • If the board does not boot from the SD card, double-check that the boot.scr file is correctly named and located in the root directory of the SD card.
   • Ensure that the SD card is properly inserted and recognized by the board.
   • If you continue to experience issues, you may need to consult the Toradex Community or support resources for further assistance.

Keep in mind that this method is not officially supported by Toradex, and success may vary depending on the specific versions of the Easy Installer and the BSP you are using.

Please, also check if these links can help you solve your problem:

How can I install QNX using microSD

Hi. I bought Apalis iMX8QN 4GB + Ixora Carrier board. I want to install QNX to the Board. Bun I cannot install. When I insert microSD card into my board, The board can’t detect files from microSD card. I used TEZI(Tordex esay intaller). When I boot up the board, I’ll see the screen below. It’s the same when you insert microSD. [image] according guide document, it should appear as below, but even if I insert microSD, the screen as below does not appear. [image] How do I install QNX on …

Apalis Evaluation Board Connected to VGA not Getting ON

hi sir, I connected DC power supply to Apalis iMX6 evaluation board and connected a VGA cable from it to the monitor. I am not able to get any output to the monitor.please help what to do. And i followed what the Toradex people said even thought i didn’t get ON the monitor…please any suggestion for that…

Loading Toradex Easy Installer | Toradex Developer Center.