Android Kinetics Image - adb support?

Technical Support
, , ,
1

Dear all.

I loaded “Kinetics Android image” simply by using easy installer and then it worked successfully in Aplais iMX8QM board + Ixora carrier 1.1B. Can I see this board through “adb” interface from Linux ubuntu PC?

[22062.846282] usb 1-1: new high-speed USB device number 63 using xhci_hcd
[22063.001315] usb 1-1: New USB device found, idVendor=18d1, idProduct=4ee7, bcdDevice= 4.40
[22063.001322] usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[22063.001325] usb 1-1: Product: APALIS-MX8QM
[22063.001329] usb 1-1: Manufacturer: freescale
infot@yjr:~/AndroidStudioProjects/ActivitySceneTransitionBasic$ adb devices
List of devices attached
(no serial number)	device

Serial number is not displayed at all. How can I use this device ? I hooked up this board through OTG USB port and JP2 jumper is open.

Best,
Todd.

2

Could you please check this article - Kynetics Android | Toradex Developer Center ?

3

I loaded Android 11 image and having similar issue with adb.

device inof:
Aplis iMX8QM 4GB WB IT V1.1 C
Ixora V1.2A
android build number: aosp_arm64-userdebug 11 SNAPSHOT-20210323 eng.develo.20210322.182619 test-keys

image
image565×748 95.8 KB

1, unable to find device on windows
image

2, no serial number on ubuntu

image
image1021×97 9.69 KB

3, wireless debugging not working
image

4, device info unable to read correctly in Android Studio (ubuntu)

image
image459×637 21.1 KB

5, fail to install apps in Android Studio (ubuntu)

image
image830×272 18.4 KB

6, no serial number on device

image
image723×524 30.5 KB

any solution?

4

Could you please try android-11_gsi-8qm_snapshot-20210709 ?

For more information about how to get this demonstration image supported and customized, get in contact with Kynetics.

5

WIFI debugging seems to work okay. However unable to get USB debugging working.
The link says connect to device via micro USB-USB with JP2 open and nothing much.
Are we missing anything here?

6

To make a micro-USB (X9) work you need to remove the JP2 and double check if nothing is connected to the bottom part of X8. For any other questions related to the Android image get in contact with Kynetics .

7

Hi @alex.tx ,
We are not using the same device as above. We have a Colibri IMX8X soc on Colibri evaluation board.
So the pins are different.
I’ll have a chat with Kynetics regarding this.

8

That’s why we recommend not hijacking a thread but rather creating a new one. As for setting HW for debugging - yes, you can use either X30 (with JP2 removed) or X29.