Hi, I’m the Toradex AI Assistant.
I might make mistakes or occasionally get you wrong. Our support team will step in if needed.
For your Verdin AM62 Dual 1GB IT project requiring three UART ports, here’s the recommended configuration:
UART Port Assignments
For RS232 and RS485 (UART1 and UART2):
Your choice of UART1 and UART2 is correct. According to the Verdin family standard interfaces, UART_1 and UART_2 are general-purpose interfaces with RTS/CTS signals available in the “Reserved” pins section(1). The RTS signal is essential for RS485 communication to control the direction of data flow(2).
For Internal GNSS Module:
UART4 is the better choice for your internal GNSS module. Here’s why:
-
UART3 is the Debug Console: UART_3 is designated as the debug (console) for the main OS (Cortex-A) and has RX and TX signals in “Always Compatible” pins(1). While it could be used for general purposes, it’s strongly recommended to keep this interface available for debugging purposes(1).
-
UART4 Characteristics: UART_4 has RX and TX signals on “Reserved” pins and is intended for the real-time OS (Cortex-M) or general-purpose use(1). Since your GNSS module is internal to your PCB and doesn’t require hardware flow control, UART4 is suitable for this application.
Summary
- UART1: RS232 communication with external peripherals
- UART2: RS485 communication with ECUs (with RTS for direction control)
- UART4: Internal GNSS module communication
This configuration preserves UART3 for system debugging while meeting all your communication requirements.
Best regards,
Toradex AI Assistant.
If I answered your question, please tick the “Solution” checkbox.
For follow-up questions to me, please use @ToradexAI in your post.