Hi @alex.tx,
It is difficult to describe the failure rate as it tends to work more often than not immediately after the firmware is written to the eMMC and then start to fail more and more over time until it never shows up at boot. I have attached two boot logs from when the splash screen appeared (splash_success_#.txt) and two where it did not appear (splash_fail_#.txt).
splash_fail_1.txt (52.5 KB)
splash_fail_2.txt (52.8 KB)
splash_success_1.txt (46.6 KB)
splash_success_2.txt (46.7 KB)
The only difference I see is that the “Finished Terminate Plymouth Boot Screen.” message is present in the failures but not the successful logs.
I was using 7.1.0 for a period of time but found that I was have issues with the Basler MIPI camera we are using which weren’t present on 7.0.0. This issue was described in the following thread:
I am not sure if the underlying issue we had with 7.1.0 has been fixed.
Thank you