How to import GPIO and toggle led on apalis imx 8 using Visual Studio Code as compiler

[ritesh.tx]

Hi @ShubhamD,

Welcome to Toradex community.

Regarding your query please check similar post below:

How to configure GPIO and toggle led on apalis imx 8 (torizoncore)using python

Hi @ritesh.tx Thanks for the reply. I tried following steps… Ran the command … docker run --rm -it --device /dev/gpiochip0 torizonextras/arm64v8-gpiod Ran commands you mentioned in the open container… sudo apt update sudo apt install python3-libgpiod created a file in nano editor led.py with following… import gpiod chip=gpiod.Chip(‘gpiochip0’) lines = chip.get_lines([ 12 ]) lines.request(consumer=‘gpio’, type=gpiod.LINE_REQ_DIR_OUT) lines.set_values(1) on running python3 le…

Please feel free to write us back if above post is not helpful with your query.

Best Regards
Ritesh Kumar