Colibri iMX6 USBOTG

Colibri iMX6S

I’m using the USBOTG port. The USB enable is on SOpin 95, however my carrier board wants a High level for enable and the default on Colibri is Low Level.

For now I’m configuring the pin for GPIO input which allows my pull ups to always enable the USB.


  1. Is there a way to configure the USB enable for High level = Enable?
  2. Can this or configuration of the PIN = GPIO input be done in the WINCE 2013 registry? I searched for this but it wasn’t clear to me.

Thanks in advance for any comments.